Plastic mould steel DIN 1.2083 ---- 1.2083 steel is a martensitic stainless steel with 12% Chromium which is sufficient to give good corrosive resistance properties. It’s best corrosive resistance is when hardened and surface is ground or polished. It has good ductility in the annealed condition but can be hardened up to 500HB (highest of the chromium grades). Martensitic Grades are known for high hardness and allowances must be made for poor weldability and usually allowances for a final harden and temper treatment. 420/1.2083 steel is magnetic and welding is not recommended.
Equivalent Grades of 1.2083 Plastic Mould Steel
Standard | Grade |
AISI/SAE | 420 |
W.Nr/DIN | 1.2083 |
JIS | SUJ420J2 |
GB | 4Cr13 |
Chemical Composition (%)
C | Si | Mn | Cr |
0.38-0.45 | ≤1.00 | ≤1.00 | 12.00-13.50 |
Heat Treatment of 1.2083 Steel
Annealing: 760 to 800℃, slow cooling in furnace (10-20℃/hr), down to approx. 600℃, cooling in air. Hardness after annealing: max. 230HB.
Stress relieving: approx. 650℃, slow cooling in furnace. Hold in neutral atmosphere for 1 to 2hours.
Hardening: 1000 to 1030℃, oil. Quenching: oil. Hot bath at approx. 300℃. Hardness obtainable, approx. 56 HRC.
Tempering: Slowly heating to tempering temperature right after hardening. Recommended to temper 2 or 3 times.
Tempering ℃ | 100 | 200 | 300 | 400 | 500 |
HRC | 55 | 53 | 52 | 51 | 50 |
* Hardening temperature: 1000℃, specimen size: dia25mm
Properties of 1.2083 Plastic Mould Steel
Well hardening with minimum distortion, very good resistance to wear and compression. In the heat treated condition this steel grade allows a very high polish
Applications of 1.2083 Steel
Inserts and smaller moulds for injection and compression of corrosive plastic materials.
Available Size of MouldSteel 1.2083 | ||||
Round: | Dia 12-50mm | hot rolled | ||
Dia 50-600mm | forged | |||
Flat/Square: | Thickness | 3-40mm | hot rolled | |
20-350mm | hot forged | |||
Width | 1000mm max |
Get quotation about tool steel 1.2083 steel round/flat bars,plate and forged block,please contact us.